Command API Quickstart
The fastest way to learn about the ZentriOS Command API is to use a desktop machine and a UART terminal application or a web browser over Wi-Fi.
To get your ZentriOS device onto a wireless network, you need to supply the device with network credentials: the wireless network name (SSID) and password. There are several ways to do this, including:
- Getting Started with the ZentriOS Web App. See below.
- Getting Started with the ZentriOS Terminal. See below.
- See Configuration and Setup for more ways to configure a ZentriOS device.
Let's get started!
Getting Started with the ZentriOS Web App
The ZentriOS Web App provides a simple way to configure the network credentials on the device using a web browser. This is particularly convenient for configuring Zentri evaluation boards, which can be put in
setup web mode without connecting a ZentriOS terminal. See ZentriOS Web App, Setup Web Mode.
Getting Started with the ZentriOS Terminal
Before configuring your ZentriOS device, it may be helpful to ensure the device is in a known state by performing a factory_reset.
Opening a ZentriOS Terminal
You can control your ZentriOS device using the ZentriOS Command API via a UART serial terminal.
For a ZentriOS evaluation board, plug the computer USB port into the evaluation board micro USB port. USB provides power and UART serial connection.
For a device not on an evaluation board, connect the terminal to device UART 1 and provide power to the device. For pinout information, see Peripherals, GPIO Functions and Pins or the device datasheet.
With the device UART connected:
- Open a communication terminal application e.g. Teraterm
- Find the UART serial (COM) port associated with the eval board
- Set the communication parameters to 115200 8N1 with NO hardware flow control
- Press the enter key. ZentriOS responds with a ready message and command prompt:
- At the ZentriOS prompt, type
versionand check for a response similar to the text below.
> version ZentriOS-220.127.116.11, Built:2015-11-11 11:11:11 for AMW106.5, Board:AMWx06-E03.2
If problems arise, see the ZentriOS Troubleshooting Guide.
Configuring Wi-Fi Credentials on the Device
You need to provide the device with the name of your wireless network (SSID) and password. To do this, enter the following commands into a ZentriOS terminal:
When you issue any ZentriOS command that requires network access, ZentriOS attempts to bring the network up using these properties.
Zentri evaluation boards have a network indicator LED to help determine successful association.
Enter the network_up command (
The network indicator LED changes its blink rate from fast (no IP address), to medium (DHCP in progress) to slow (DHCP successful, IP address obtained).
To ensure that variables like the AP name and password persist after a reboot, use the save command:
Verifying the Internet Connection
To demonstrate that the device is connecting to the Internet, try downloading a web page:
Now that you have established control over your ZentriOS device, you can experiment with the rich set of ZentriOS features using the ZentriOS Command API. There are many application notes demonstrating ZentriOS networking applications. See Application Examples.
As well as the ZentriOS documentation provided on this website, ZentriOS also provides interactive command line help:
- At the ZentriOS prompt, enter
Help options for the ZentriOS Command API ... help all -> Print a list of all Commands and Variables help commands -> Print a list of Commands help variables -> Print a list of readable Variables help <command> -> Print help for a specific Command help <variable> -> Print help for a specific Variable Additional help is available online at http://docs.zentri.com