Getting Started with WiConnect
WiConnect provides a secure wireless network link between your host microcontroller (MCU) and a network.
To join a wireless network, you need to supply the module with network credentials: the wireless network name (SSID) and password. There are several ways to do this.
Let's get started!
Using the WiConnect Web App
The WiConnect Web App provides a simple way to configure the module network credentials using a web browser. This is particularly convenient for configuring ACKme evaluation boards, which can be put in
setup web mode without connecting a WiConnect terminal. See WiConnect Web App, Setup Web Mode.
Opening a WiConnect Terminal
You can control your ACKme module with WiConnect commands via a USB UART serial terminal:
- Plug your ACKme WiConnect evaluation board into a USB port (USB provides power and UART serial connection.)
- Open a communication terminal application e.g. Teraterm
- Find the UART serial (COM) port associated with the eval board
- Set the communication parameters to 115200 8N1 with NO hardware flow control
- Press the enter key. WiConnect responds with a ready message and command prompt:
- At the WiConnect prompt, type
versionand check for a response similar to the text below.
WiConnect-22.214.171.124, Built:2014-10-20 13:35:04 for AMW006.4, Board:AMW006-E03.2
If problems arise, see the WiConnect Troubleshooting Guide.
Configuring the Module for a Wi-Fi Network
You need to provide your module with your Access Point (AP) SSID and password. You can do this via the serial terminal, with the following commands.
When you issue any WiConnect command that requires network access, WiConnect attempts to bring the network up using these properties.
ACKme evaluation boards have a network indicator LED to help determine successful association.
Enter the network_up command (
The network indicator LED changes its blink rate from fast (no IP address), to medium (DHCP in progress) to slow (DHCP successful, IP address obtained).
There are several other ways to configure your module to connect to a Wi-Fi network. See Configuration and Setup.
Verifying the Internet Connection
To demonstrate that the module is connecting to the Internet, try downloading a web page:
Now that you have established control over your ACKme module, you can experiment with the rich set of WiConnect features. There are many application notes demonstrating WiConnect networking applications. See application examples.
As well as this WiConnect documentation, there are various WiConnect help commands:
- At the WiConnect prompt, enter
The following help options are available ... help all -> Print a list of all Commands and Variables help commands -> Print a list of Commands help variables -> Print a list of readable Variables help <command> -> Print help for a specific Command help <variable> -> Print help for a specific Variable Additional help is available online at http://wiconnect.ack.me
- Enter help all for a full list of commands and variables.
- Enter help commands to list commands only, or help variables to list variables only.
- Enter help
to show help for an individual command or variable.